
• Smaller: By pressing the “Clean” button you can decrease the size of the ice cubes made.
The green LED will blink as the size is lowered. When the lowest possible size is reached,
the green LED will remain lit.
• Bigger: By pressing the “Mode” button you can increase the size of the ice cubes made.
The red LED will blink as the size is increased. When the largest possible size is reached,
the red LED will remain lit. After 10 seconds of inactivity, the unit will return to the previous
mode.
NOTE: During the ice size adjustment, the “Bin Full”, “Ice” and “Harvest” LEDS blinking all
at once indicate that the unit is in the default factory setting for ice size.
Making Ice
Once the ice maker has been properly installed, it is ready for operation.
• Turn on the water tap, let the water trough fill, then set the ON/OFF button to the ON
position on the front panel. The ice maker will start working automatically.
• After 3 minutes, the machine will automatically switch to the freeze cycle, and the sound of
water flowing will be heard.
• When the batch of ice has been fully formed, ice will automatically be harvested to the ice
storage bin.
• When the ice storage bin is full, the sheet of cubes will not fall completely and will hold the
ice-full probe open. The machine automatically stops making ice and progresses to the cold
preservation stage. During this stage, the compressor works regularly to keep the
temperature low to reduce melting.
10
WWW.VINOTEMP.COM
swings back to operating position.
water supply tap off when the ice maker is working.
elting, keep the ice maker door properly
ce Maker Cycles
cycles it will run.
ssor is pumping refrigerant, the fan motor is
• The unit will start making ice again after the ice cubes are removed and the ice-full probe
IMPORTANT:
• Never turn the
• Never touch evaporator when unit is running.
• To promote proper ice formation and reduce m
closed except when taking ice from the unit.
I
Your Ice Maker has two distinct
• Freeze: During the freeze cycle, the compre
blowing air, and the water pump is circulating water. When the batch of ice has been fully
formed, the ice maker stops and begins the Harvest cycle.
Commenti su questo manuale